Wet wood suitable materials for industrial applications are usually used for low industrial, density, mechanical strength, mechanical properties, perishability, etc., not directly used, practicality and practicality after treatment and drying. It mainly has the following aspects.

On May 11th, the workshop of the factory was very busy. The order from the old customer in Malaysia was being loaded methodically. Thank you for the trust of the old customer.

During the drying process of wood, in the process of water evaporation in wood, due to the different combinations of various water in wood and wood, the properties of water in wood at each stage are different, and the properties of wood corresponding to this are also different. Therefore, in the wood drying process, the evaporation process of water in the wood should be reasonably controlled, so as to improve the drying speed as much as possible on the premise of ensuring the drying quality of the wood.

When wood is drying, the drying defects that often occur in wood drying include: internal cracks, surface cracks, end cracks, bending, shrinkage, charring, severe surface discoloration, and uneven drying.

The advantages of dehumidification and drying: 1Save energy;. 2, due to the low drying temperature, so the design of the drying room and the use of materials are not high requirements, as long as reasonable air tight, waterproof box insulation. Factories can simply design and build drying chambers themselves; 3. The peak energy required in the drying process is low; 4, the use of electric energy, little pollution to the surrounding environment.

Air drying of wood is commonly known as natural drying. Air drying of wood is to stack wood in an open courtyard or under a ventilated shed, and use the heat in the atmosphere to evaporate the moisture in the wood to dry it. Although the method of air drying wood may seem simple, the drying process involves many physical laws, such as combining atmospheric drying with other drying methods, is a way to save energy.

"Natural is the best." In modern society, this has almost become a consensus of people. Everyone knows the reason: modern technology is used in various fields, and almost all products are linked to technology, so that natural things are becoming more and more scarce, and people are beginning to miss the "natural gas" that can be seen everywhere. good time.

Wood modification is the process of improving the properties of wood. It uses chemical, biological or physical media to act on the wood to enhance the desired properties of the wood during the service cycle. In addition, the modified wood itself should be non-toxic during the service cycle and not release any toxic substances during or after the service cycle.

How to prevent and control the blue of wood? Is there a good way?

The discoloration of wood, simply put, is the color change on its surface due to the action of the environment (sunlight, oxygen, moisture, temperature) and microorganisms (fungi).