The basic principle and drying essence of dehumidification drying and conventional drying are the same. Both rely on the convection heat exchange between the hot air in the wood drying room and the wood to be dried, and the air heats the wood and absorbs the moisture evaporated from the wood. The main difference between the two is the method of dehumidifying the air.

Air drying of wood is commonly known as natural drying. Air drying of wood is to stack wood in an open courtyard or under a ventilated shed, and use the heat in the atmosphere to evaporate the moisture in the wood to dry it. Although the method of air drying wood may seem simple, the drying process involves many physical laws, such as combining atmospheric drying with other drying methods, is a way to save energy.

Internal wood cracking occurs inside the wood, cracking along the wood rays, such as honeycomb, also called honeycomb cracking. There are no cracks on the surface, only sawing can be found. But it is usually accompanied by uneven appearance or significant shrinkage, or charring, or lighter weight. This is characteristic of over-drying.

Surface cracks are longitudinal cracks that occur along the wood rays on the outer surface of sawn timber (usually the outer cut surface of a chord-cut board). It is caused by excessive surface tensile stress in the early stage of drying

"Natural is the best." In modern society, this has almost become a consensus of people. Everyone knows the reason: modern technology is used in various fields, and almost all products are linked to technology, so that natural things are becoming more and more scarce, and people are beginning to miss the "natural gas" that can be seen everywhere. good time.

Wood modification is the process of improving the properties of wood. It uses chemical, biological or physical media to act on the wood to enhance the desired properties of the wood during the service cycle. In addition, the modified wood itself should be non-toxic during the service cycle and not release any toxic substances during or after the service cycle.

There are many ways to dry wood. According to the way the moisture is discharged from the wood, it is divided into three types: thermal drying, mechanical drying and chemical drying.

How to prevent and control the blue of wood? Is there a good way?