Matters needing attention when piles or trucks enter the drying room
(1) The wood to be dried in the same drying room must have the same species or similar material properties, the same thickness, and the initial moisture content is basically the same.
(2) Be careful not to damage the door, wall and indoor equipment when loading materials. The materials should be parked or stacked stably and neatly.
(3) The windward side must be filled with piles without leaving gaps. That is to say, for the track-type drying room, the airflow passes through the material pile horizontally, and must be filled along the length and height of the drying room; for the forklift loading and unloading drying room, the airflow passes through the material The number of columns), but the total length and height of the stack, or the number of nodes and stacks of each stack cannot be reduced, leaving a gap on one side to short-circuit the air flow, resulting in uneven drying and drying defects.
(4) In the same row, the ends of each section pile should be as close as possible without leaving gaps, and the front and rear positions of adjacent row piles should be slightly staggered, so as to avoid unavoidable interpenetration of the end-to-end connection of the piles or the unavoidable gaps at the ends.
(5) Pay attention to the heavy objects on the top of the pile.
(6) Place the moisture content inspection board and the stress inspection board. If the electric moisture content measurement method is used, the moisture content measurement points should be at least three, and they should be arranged in different positions in the material pile in a balanced manner. Finally, the connecting wires should be inserted into the corresponding sockets installed on the chamber wall. Weighing method, the initial moisture content and initial weight of the inspection board should be measured, and the total dry weight of the inspection board should be calculated. After the end of the inspection board is sealed with waterproof paint, it is put into the material pile through the inspection window or inspection door, and the Prevent condensation from dripping on.
Fujian Zhangping CHIQIN Technology Co. Ltd, is professional in wood drying over 20 years, covering Aluminum Wood Drying Kiln, Heat Pump Wood Drying Kiln without heat source, Veneer Drying Equipment, Food Drying Kiln, Kiln Components etc with high quality and reasonable price. Hope to establish business relationship with you!
